Ford RS200 Database

Does anyone know whether the Speedline split rims are made from normal alloy, alloy with some Magnesium content or entirely Magnesium The centre will be Magnesium alloy... Not sure what other metal is in there. They would have been "low pressure" cast back in the day. The outer rim on the...

I am having some oil pump rotors made for the front mounted pressure oil pump, these will be wider than the originals so the housing will need machining (something I can sort). The rotors will be 30% wider than the originals a modification done to some competition engines, which will cure to low id...

Hi Darrell,
Might be worth trying the 6r4 community too as they are the same rev counter albeit adjusted for 6 cylinder engines.

But expect to pay upward of £400

Do you have a photo of what you need ?

089 wrote:Hi Guys

friend of mine looking for a rear calliper. CP 2541 -101C . If anyone can assist

Regards

David

They push very well in the mode you are in, I suspect you have binding brake calipers rubbing the discs.

I have some other photos of the later red RS200 with a white RS turbo in the garage. I didn't post them because they we taken outside the Robson family Home, and IMO felt a little discretion should be observed. the picture I put on is on Graham Robson Author profile page I tried to contact him abou...

Photo's will be great,
I reckon 99% of the cars have floor delamination by now if they haven't already been repaired, the general consensus is the 1980's adhesive they used was not much good.
What have Arch quoted you to repair them ?

Can't get better than that Wayne !

I would imagine 40 off RS200's would cost Ford over a million pounds each to produce nowadays by the time the jigs, moulds, pattern work, machining & fabrication is completed.